Application notes

Application notes

Daintree provides application notes that contain specific configuration information and usage instructions to assist in using various ZigBee development and evaluation kits with the Sensor Network Analyzer:

Additional information can be found on Daintree's dedicated partner pages.

General (applies to multiple kits and boards)

• Start-up commissioning and binding using the SNA
• Binding and group commissioning using the SNA
• "Active" analysis and configuration using the SNA
• Using measurements with the SNA

Texas Instruments (Chipcon)

• Using the TI CC2400EB with the SNA
• Using the TI CC2430 with the SNA
• Start-up commissioning using TI's SoC and the SNA
• Locating ZigBee nodes using TI's CC2431 and the SNA
• Upgrading firmware over-the-air using TI's SoC and the SNA
• SNA Firmware Guide for TI's CC2430 and CC2431

Freescale

• Using the Freescale 802.15.4 Analyzer with the SNA

Jennic

• Using Jennic Evaluation Kits with the SNA

Integration

• Using the Integration Associates USB Dongle with the SNA

Ember

• Using the Ember EM250 with the SNA
• Using the Ember EM2420DK with the SNA
• Start-up commissioning using Ember's EM250 and the SNA

OKI

• Using the Integration Associates USB Dongle (provided with the Oki ZigBee Development Kit) with the SNA

Renesas

• Using the Integration Associates USB Dongle (provided with the Renesas ZigBee Development Kit) with the SNA

NEC

• Using the NEC 78K0 UZ Stick with the SNA

Atmel

• Using the Atmel ZLink USB Adapter Board with the SNA

One RF

• Using the One RF ZCP demo case with the SNA